300-5599-00 rev. C
• 09/18
Insert Screw
(small pink patch on end)
325-5052-00
Glide Inserts placed
into the large holes
Leave these two holes open
5/16-18 X 4 BHCS Black
718-255-102
Curved Washer
225-2050-00 or 225-3522-00
Left Leg Assembly
Right Leg Assembly
Side holes
Cross Tubes
5/16-18 X 4 BHCS Black
718-255-102
Curved Washer
225-2050-00 or 225-3522-00
Leave these two holes open
Lower holes
72” AnthroBench
Assembly Instructions
Step 3
Position the Right Leg Assembly
(from Step 2)
with two
Cross Tubes as shown. Insert one Bench Cap Screw
with a Curved Washer through a side hole, carefully
threading the Screw into the Cross Tube.
Repeat entire procedure for the remaining three
side holes.
Step 2
Orient one Bench Leg Assembly with one Base Tube
Assembly
(from Step 1)
. The Glide Inserts should be
facing down.
Insert one Bench Cap Screw through one Curved Washer,
then carefully insert through one of the lower holes on
the Base Tube, threading into the Right Leg Assembly.
Repeat this procedure for the remaining three lower
holes on the Right and Left Leg Assembly.
If you are installing Bench Glides, install them now
by threading one into each Glide Insert. If you are
upgrading to 5” Casters, install them now following their
enclosed instructions.
Left Leg
Assembly
Right Leg
Assembly
Glide Inserts
Thread one Glide
into each Glide Insert
A F T E R t h e B a s e
Tubes have been
installed to the Legs.
NOTE: Loosen these
Support Screws (if
needed) to allow the
Base Tube to install
easier.
Step 1
Install two Bench Glide Inserts into each Bench Base
Tube and secure with one Insert Screw per Insert.
Pop two End Caps into the ends of both Base Tubes.