ERGOTECH GROUP, INC.
8 Westchester Plaza
Elmsford, NY 10523
914-347-3800
www.ergotechgroup.com
Installation Instructions
Upper Tier Units Only:
Slide the upper tier bars into the slots in the top
plate and guide them down into the unit guide block until they are fully
seated. This will line up the rear holes in order to place the securing
bolt later. Do not place the bolts until the center cross support plate is
in place joining the upright bars. Once the upper tier is fully assembled
place the bolts from the rear and tighten. Again starting from the center,
attach the extrusions to the upper tier as before.
To adjust monitors:
Left/Right and Up/Down: Grasp monitor with both hands and adjust to desired position.
To tension the vertical adjustment to the weight of monitor: Tighten the 5mm bolt on the right side of the pivot
with the hex wrench provided.
2) Once the base unit is secured, begin attaching the extrusions from
the unit outward. Place the telescoping extrusions onto the main
unit joints and secure from the backside with the knobs (as shown
in Fig.3). Next secure the non-telescoping outbound extrusions with
the knobs as before.
3) Note: If mounting larger sized or wide format monitors
and additional extrusion length is required, simply extend
the inner telescoping extrusions to provide the necessary
space (as shown in Fig.4). They must be extended equally
on each side of the unit to insure mounting symmetry.
4) Attach quick release pivots to back of each monitor using
Phillips head screws provided. Be sure that the silver release
button is positioned toward the top of the monitor. (as shown
in Fig.5).
Place each monitor on the mounting blocks by tipping the monitor
back approximately 45 degrees and then down until the silver release
button engages grove and clicks down into place.
Fig .3
Fig .5
Fig .4
Silver Release button
Fig .6