Ergon Crafco SUPER SHOT 125, Parts Manual

Page: 39 / 176

Super Shot 125 DC 70CFM EU Part Manual
Chapter 5 Operating Instructions
©2022 by Crafco, Inc. All Rights Reserved
………………..…………………………………..….Operating Instructions 5-13
5.11 Overnight Heater Use
An overnight heater rod is available as an option. 24190 110V and 24194 220V. The overnight
heater may be used to maintain an overnight heat transfer oil temperature of approximately 200-
250°F (93.3°C)
Step Action
WARNING
The overnight heaters are for overnight use only. If the overnight heater is used, the
material must be dispensed the next day. If the material can’t be dispensed, the
machine needs to be heated to mixing temperatures, and agitated to prevent
settling. If you don’t dispense the material after 1 nights use, you risk damaging the
material and possibly the machine due to settled material, which can harden in the
bottom of the material tank
1 Attach the heater power cord to a suitable extension cord.
2 Attach the extension cord to its own outlet rated for 15 amps minimum.
WARNING
Suitable extension cord size requirements for 110 Volt use:
25-50 FT
• 16-20 Amps • 12 Gauge (Heavy Duty) or 10 Gauge (Extra Heavy Duty)
100 FT
• 16-20 Amps • 10 Gauge (Extra Heavy Duty)
Suitable extension cord size requirements for
220 Volt use:
25-50 FT
• 8-10 Amps • 14 Gauge (Medium Duty) or 12 Gauge (Heavy Duty)
100 FT
• 8-10 Amps • 12 Gauge (Heavy Duty)
Failure to use the correct size extension cord could result in damage and
possible fire!
3
Disconnect the heater when using the machine’s burner system.
CAUTION
Do not use the heater without heat transfer oil in the tank. Doing so will overheat and
damage the heater, and it will have to be replaced.
Table 5-10 Overnight Heater Use