Ergon CRAFCO SUPER SEALCOATER 550, Parts Manual

Page: 37 / 98

Super Sealcoater 550 & 800 Part Manual
Chapter 6 Maintenance Instructions
©2019 by Crafco, Inc. All Rights Reserved………………..………………………………..….…Maintenance Instructions 6-1
6.0 Maintenance Instructions
This chapter contains all normal maintenance instructions to properly maintain your machine.
6.1 Engine
Refer to the manufacturer’s operating and maintenance instructions for the engine.
For an online PDF manual, visit https://engines.honda.com/models/series/gx .
6.2 Hydraulic System
Check hydraulic fluid daily.
Change hydraulic filter every 250 hours of machine operation. Replace if necessary.
Change hydraulic fluid every 500 hours of operation.
6.3 Material Pump 2”
Refer to separate manual in packet. For an online PDF manual, visit
https://wildenstore.psgdover.com/products/aodd-pumps/item-08-14756-wilden-2inch-aluminum-pro-
flo-shift/
.
6.4 Water Pump 1/4"
Refer to separate manual in packet. For an online PDF manual, visit
https://wildenstore.psgdover.com/products/aodd-pumps/item-00-9612-wilden-025inch-
polypropylene-pro-flo/
.
6.5 Lug Nuts
Torque all nuts/bolts before first road use and after each wheel removal. Check and torque after
the first 10 miles, 25 miles, and again at 50 miles. Check periodically thereafter.
Torque in stages as follows:
First stage 20-25 foot-pound (ft-lb)
Second stage 50-60 foot pound (ft-lb)
Third stage 90-120 foot pound (ft-lb)
Tighten bolts and nuts in the sequence shown in Figure 6.1 Lug Bolt Tightening Sequence.
Figure 6.1 Lug Bolt Tightening Sequence
4-BOLT 5-BOLT 6-BOLT
1
2
3 4
1
2
3 4
5
1
2
3
4 5
6