22
ergoselect 1
6 Operation
Use the right and left softkeys (
↑
↓
) to select the parameter
to edit.
The protocols can be configured with steps (increments) or
ramp (gradual changes).
Protocol
6.
Select
Step
Basic Load
20 W
Stage Time
min
Load Stage
W
Select
Figure 6 – 21: Selecting the parameter to edit
After confirming with
Select
, the corresponding value is
highlighted and can be adapted with the keys (
↑
↓
).
Pressing
Select
will save the new value.
The other parameters are edited in the same way.
You exit the configuration with
.
Protocol
6.
Select
Step
Basic Load
20 W
Stage Time
min
Load Stage
W
Select
Figure 6 – 22: Editing the parameter value
6.9.3 Contrast
The display contrast is adjustable in the range from 0 to 100 %.
Contrast
50 %
Select
Figure 6 – 23: Adjusting the display contrast
6.9.4 Load Change
Here you determine the increments for each load change.
Depending on your choice, each key press will change the
load by +/–1, 5, 10 or 25 watts.
Load Change
+/–
1 Watt
+/–
5 Watt
+/–
10 Watt
+/–
25 Watt
Select
Figure 6 – 24: Selecting the increment for manual load changes
