Installation
The following steps must be performed by two
people.
NB. If concrete wedge anchors are not used and you
decide on other mounting hardware, please follow
the installation instructions as provided with the
hardware.
Determine the desired viewing location.
Place the wall mount into position against the wall
and level the mount.
Mark off four holes to be used for securing the
mount.
When determining viewing height, the centre of
the TV should be at eye level while sitting in an
upright position. When using the fl at panel as room
decoration, raise it to the point where the bottom of
the screen is at eye level while sitting and the top is
eye level when standing.
Next, drill holes using a masonry bit for your
anchors.
Insert a commercially available concrete anchor into
each hole.
Use a hammer and lightly tap each anchor into
place so that only the threaded shaft of the concrete
wedge anchor is protruding from the wall.
Once all the anchors are in place, move the wall
bracket into position.
Attach the nut onto the threaded shaft that is
protruding from the wall.
Re-level the wall plate and tighten all concrete
wedge anchor nuts at this time.
If concrete wedge anchors are not used and you
decide on other mounting hardware, please follow
the installation instructions as provided with that
hardware.
Do not overtighten the concrete wedge anchors.
1
2
3
Concrete Surface Installation
1
2
3
4
5
Mark
Level
6
7
8
9
Drill
Threaded Shaft
Hammer
Concrete Wedge Anchor
Level
Threaded Shaft
Nut
1/2” Socket
5
