Installation Instructions
Model: KTG-Series
5
Figure 3: Mount Centris Head with Pole Clamp
NOTE:
Equally tighten screws (230) against front pole
mount (210) and the rear pole clamp (220). (see
Figure 4)
Figure 4: Tightening clamp to mount
10. Secure rear pole clamp (220) to front pole mount
(210) and pole by tightening three BHCS (230) using
5/32" hex key (120). (see Figure 3)
KTG-220, 320, And 440 Assembly
To assemble the KTG-220, 320, and 440:
NOTE:
If mount is being installed without the base
through a flat surface, proceed to Grommet
Mount Installation.
1.
Assemble pole (50) to base (40) using one 3/8-16 x 1"
FHCS (90). (see Figure 2)
2.
Assemble pole clamp back (240) to pole mount front
using two FW (250) and two BHCS (260) using a
5/32" hex key. (see Figure 5)
3.
Secure pole mount back (240) to pole mount front and
pole by tightening two BHCS (260) using a 5/32" hex
key.
Figure 5: Assemble Array Rail to Pole
Display Installation
Attach Centris Head to Flush Mount Display
CAUTION!
CAUTION:
If display uses a screw size other than
those included in the kit, DO NOT use the screws
provided. Using the wrong screws could result in
damage to your monitor.
1.
Install two M4 x 12mm Phillips pan head screws (160)
into two upper mounting holes in display back.
(see Figure 6)
NOTE:
DO NOT fully tighten at this time.
2.
Hang display on Centris head. (see Figure 7)
3.
Install bottom two M4 x 12mm Phillips pan head
screws (160) through Centris head mounting holes
and into lower mounting holes in display back.
4.
Tighten ALL four M4 x 12mm Phillips pan head
screws (160). (see Figure 8)
(210)
(60)
(220)
(230)
(230)
Keep equal
distance between
mount and
clamp when
tightening
(210)
(220)
Pole Clamp Back (240)
Pole
(250)
(260)
Pole Mount front
with Array
