1. Using a 5mm Allen key, loosen the tie rods two to three revolutions. Do not fully unscrew
and remove the tie rods.
2. Slide the tablet arm bracket into place. Re-tighten the tie rods using a 5mm Allen key. Note:
if you have SmartRow installed, please go to
support.ergatta.com
for instructions.
3. Using two 5mm Allen keys and the provided JCN and JCB hardware, attach the tablet arm to
the tablet arm brackets.
4. Raise the tablet arm and lock it in place. Line up and slide the tablet onto the tablet arm.
5. Using the 1/8” Allen key, install the bolt to secure the tablet to the tablet arm.
6. Install the power and USB cable into the righthand side of the tablet.
7. Install the mini-USB end of the cable into the back of the S4 monitor.
8. Place the adhesive cable retainers along the righthand side of the bottom deck; place the
USB cable into the wire retainers. Make sure the wire does not make contact with any of
the moving parts of the WaterRower.
9. Plug the small end of the power cable into the side of the tablet arm. Note: This plug will
still have some metal showing when fully plugged in; pushing too hard may result in
damage to the power connector or monitor.
1. To power off your tablet monitor, press and hold the power button on the back of the tablet
for three seconds.
2. Tilt the tablet backwards to its stowed position (it will snap into place). Then, pull the
handle on the tablet arm bracket upward to unlock and lower the tablet arm to its resting
position. Take care when lowering the arm that the magnets in the arm rest on the bolts
of the top deck and do not rest on the wires.
A S S E M B L Y & U S A G E
Assembly Instructions
Storage Instructions
4
An instructional assembly video can be found at:
https://erga.io/upgrade-assembly
