Erbauer ERI604IPD, User Manual, Page: 16 / 24

Warning:
When battery charge runs out after continuously
use or exposure to direct sunlight or heat,
allow time for the tool to cool down before re-
charging to achieve the full charge.
CHARGING INDICATOR
This charger is designed to detect some problems
that can arise with battery packs. Indicator lights
indicate problems (see table below). If this occurs,
insert a new battery pack to determine if the charger
is OK. If the new battery charges correctly, then the
original pack is defective and should be returned to
a service center or recycling service center. If the
new battery pack displays the same problem as the
original Battery Pack, have the charger tested at an
authorized service center.
Indicator
ON/OFF
flash
Status
Red on
Charging
Red flash
- - - - - Defective Battery
Green on
Fully Charged
Green flash
- - - - - - Hot/Cold Delay
OPERATION
1. COLLET LOCKING SLEEVE
The collet accepts only standard 1/4” hexagonal
shank accessories with power groove. Do not use
this tool as a drill. Tools equipped with shut-off
clutches are not designed for drilling applications.
The clutch can shut off automatically and without
warning. Attempting to restart drilling after shut-off
has been reached can cause the tool to twist out of
your hand until the clutch again reaches shut-off. Do
not attempt to insert quick change type drill bits into
this chuck.