OPERATION INSTRUCTIONS
Note:
Before using the tool, read the
instruction book carefully.
1. Before using your cordless lamp
Your battery pack is
UNCHARGED
and you must
charge once before use.
Warning:
The charger and battery pack are
specifically designed to work together so
do not attempt to use any other devices. Never
insert or allow metallic objects into your charger
or battery pack connections because an electrical
failure and hazard will occur.
2. Install the charger stands (See Fig.1-1,
1-2, 1-3)
Slide the two charger stands (A) into the both
grooves on back of the charger (6).The charger
can stand as shown in Fig.A-3.
3. Charge the battery pack (See Fig.2)
Connect the battery charger to the power supply
and the green light (7) will illuminate. Slide
the battery pack into the charger to make the
connections. The green light (7) will be off and the
red light (8) will illuminate to show charging has
started. A discharged battery at normal ambient
temperature will take approximately 1 hour to
reach full charge. When charging is completed
the green light (7) will illuminate while the red
light (8) is off.
Warning:
When battery charge runs out
after continuously use or exposure to direct
sunlight or heat, allow time for the tool to cool
down before re-charging to achieve the full
charge.
Note:
This charger is designed to detect some
problems that can arise with battery pack. (see
table below)
Fig 1-2
Fig 1-1
Fig 1-3
Fig 2
6
A
7
8
