18V LI-ION RECIPROCATING SAW
may cause irritation or burns.
6. Service
a. Have your power tool serviced by a qualified repair person using only
identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
ADDITIONAL SAFETY INSTRUCTIONS
for cordless reciprocating saws
1. Remove the plug from the socket before carrying out any adjustment, servicing or
maintenance.
2. Fully unwind cable drum extensions to avoid potential overheating.
3. When an extension cable is required, you must ensure it has the correct ampere
rating for your power tool and is in a safe electrical condition.
4. After long working periods external metal parts and accessories could be hot.
5. Your cordless saw is a hand held tool, do not clamp your cordless saw.
6. Always wear dust mask.
for charger
1. Only use the battery charger specifically stated on the base of the battery.
2. Your charger is double insulated for additional protection against a possible electrical
insulation failure within the tool.
3. Charger is for indoor use only.
4. If the charger supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
5. Ensure your mains supply voltage is same as indicated on the rating plate.
for battery
1. Always remove the battery pack from the charger immediately after re-charging is
completed.
2. When not in use, remove a charged battery pack from the charger.
3. Do not charge a damaged battery pack.
4. Do not charge non-rechargeable batteries.
5. Lithium-ion and lithium polymer cells and battery packs may get hot, explode or
ignite and cause serious injury if exposed to abuse conditions.
6. Do not install the battery backwards so the polarity is reversed.
7. Do not connect the positive terminal and negative terminal of the battery to each
other with any metal object (such as wire).
8. Do not carry or store battery together with necklaces, hairpins or other metal
objects.
9. Do not pierce the battery with nails, strike the battery with a hammer, step on the
battery or otherwise subject it to strong impacts or shocks.
10. Do not solder directly onto the battery.
11. Do not expose battery to water or salt water, or allow the battery to get wet.
12. Do not disassemble or modify the battery. The battery contains safety and protection
devices, which, if damaged, may cause the battery to generate heat, explode or ignite.
The protection circuit module provided with battery packs is not to be used as a
CSR18L.1-M-071008.indd 5
2007-10-9 17:15:55
