Erbauer ERB905D, User Manual

Page: 10 / 16

Fig 5
Fig 7
loosen the 3 bolts approximately 1/2 turn clockwise.
Holding the blade clamp (7) in position, using
a piece of wood slides the blade (8) out of the
blade clamp (7) and depress the guard (9) to
remove the blade from the blade clamp. Note:
there is no need to remove the blade clamp (7)
as this can change the factory settings for cutting
blade height control. Do not adjust the height
adjusting screws (10). Use a new blade or reverse
the existing blade, then depress the guard and
slide the blade back into the blade clamp in the
connecting orientation. Check the blade is equal in
the clamp and the blade edge is level with the
baseplate side. Tighten all bolts equally. Before
connecting the power cord, rotate by hand to
check the drum is free to rotate (See Fig 6).
Warning: Remove power cord from
mains before making adjustments or
changing blades.
7. FITTING A DRIVE BELT
Should the drive belt fail due to a sudden load
applied when cutting, remove the screws and belt
cover (11). Cut the belt and remove it. Clean any
debris from the belt pulleys and surrounding area.
Fit the new belt (Not supplied with your tool) over
the small pulley (12) and push the belt onto the
large pulley (13) and rotate the large pulley at the
same time (See Fig 7).
Warning: The cutting blades will be
turning and may cause injury.
Warning: Remove power cord from
mains before making adjustments or
changing blades.
8. FITTING A DUST BAG
This accessory can be fitted by sliding the dust
bag inlet over the planer exhaust pipe (5) as far as
possible. The dust bag will reduce the efficiency of
the exhaust system and the bag must be emptied
frequently to maintain the efficiency. To empty,
open the zip on the rear of the dust bag.
9.EXTERNAL DUST EXTRACTION
The exhaust outlet is best connected to a suitable
external dust extraction machine e.g. vacuum
cleaner.
Fig 6
�
10
7
9
8
13
12
SFX-ERB905D-M-050608.indd 10 2005-6-9 9:31:03