25
2. Ensure that the heads of the hex screws are facing away from the track and
therefore accessible.
3. Position the connector half way into the channel, so that one of hex screws
is within the channel and the head is exposed.
4. Tighten the hex screw clockwise to secure the half of the connector connect
to the track. (D3)
5. Now repeat this procedure, inserting the second connector into the lower
clamp channel (on the underside of the track).
6. Again, ensure the heads of the hex screws are accessible, and secure the
second connector in position by tightening the hex screw anti-clockwise. (D3)
7. Guide the free ends of the two track connectors into the clamp channels of
the second track. (D4)
8. Tighten the hex screws on the face and underside of the second track and
ensure all hex screws fixed firmly. (D5) Ensure that the two halves of the track
are fitted together securely.
1. Press the plunge lock button (1) and then the ON/OFF switch (2) to switch
the saw on.
2. Release the ON/OFF switch (2) to switch the saw off. (E)
Note
: Pressing the plunge lock button (1) unlocks the
plunge cut mechanism at the same time, so that the
motor can be moved downwards. The saw blade
emerges from the protective cover. When lifting the
saw the motor slides back into the initial position.
CONNECTING RODS FOR TRACK(D2-D5)
SWITCH ON/OFF
Using the track connectors supplied in the track pack, you can connect lengths
of track for long cuts. Each track connector (d) comprises a spacer (a) and an
expansion bar (b) with four hex screws (c). Assemble each connector by fitting
the spacer (a) to the side of the expansion bar (b) opposite the heads of the
hex screws. (D2)
1. Thread one track connector into the upper clamp channel (on the face of a
length of the track).
Summary of Contents for ERB690CSW
