750W 115mm ANGLE GRINDER
ERB666GRD
accessory in contact with the workpiece.
Always start at no load to achieve maximum speed
then start working.
Do not force the disc to work faster, reducing the
Disc’s moving speed means longer working time.
When grinding, always work with a 30° to 40°
angle between disc and workpiece. Larger angles
will cut ridges into the workpiece and affect the
surface finish. Move the angle grinder across and
back and forth over the workpiece.
When using a cutting disc, never change the
cutting angle otherwise you will stall the disc and
angle grinder motor or break the disc.
When cutting, only cut in the opposite direction to
the disc rotation. If you cut in the same direction as
the disc rotation the disc may push itself out of the
cut slot.
When cutting very hard material best results can
be achieved with a diamond disc.
When using a diamond disc it will become very
hot. If this happens you will see a full ring of sparks
around the rotating disc. Stop cutting and allow
cooling at no load speed for 2-3 minutes.
Always ensure the workpiece is firmly held or
clamped to prevent movement.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication
or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working
controls free of dust. Occasionally you may see
sparks through the ventilation slots. This is normal
and will not damage your power tool.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
