1250W 6kg HAMMER DRILL ERB575DRH
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Caution:
Keep the container of grease away
from children.
10. TO REPLACE THE BRUSHES NOT PROVIDED
(See Fig.7, 8)
Disconnect the plug from the power supply.
Unscrew the carbon brush cap with screwdriver.
Remove the carbon brush. Check the length of the
brush and replace if under 6mm. When brushes need
replacement always renew both brushes, even if one
is still more than 6mm long.
Completely screw down the carbon brush cap.
Check that the tool is working. Before use, allow it
run for a few minutes to enable the brushes to settle.
Warning!
The carbon brushes must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
WORKING HINTS FOR YOUR TOOL
1. Reduce the pressure on the drill bit when it is about to
break through. This will prevent the drill from jamming.
2. When drilling a large hole, first drill a pilot hole using
a smaller drill bit.
3. Always apply pressure to your drill bit in a straight
line, and if possible at right angles to the workpiece.
4. Never change the operating mode whilst the drill is running.
5. Do not apply excessive pressure to the tool when
chiseling. Expressive force does not speed up the work.
MAINTENANCE
Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Always store
your power tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation
slots. This is normal and will not damage your power tool.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
TROUBLESHOOTING
1. If your power tool does not start, check the plug on
the power supply first.
2. If your hammer becomes too hot in use, set the
hammer switch to the drill mode and allow your drill to
operate at maximum speed without load for 2 minutes.
