1500W 190mm Circular Saw
ERB566CSW
For a 45° bevel cut, use the 45° guide mark to align
with your parallel guide scale. Securely clamp the
parallel guide (20) (See Fig. 6). Always make a trial
cut to check the setting.
WORKING HINTS FOR YOUR CIRCULAR
SAW
If your power tool becomes too hot, run no load
for 2-3 minutes to cool the motor. Avoid prolonged
usage at very low speeds. Always use a blade
suited to the material and material thickness to be
cut. The quality of cut will improve as the number
of blade teeth increases. Always ensure that the
work-piece is firmly held or clamped to prevent
movement. Support large panels close to the cut line.
Any movement of the material may affect the quality
of the cut.The blade cuts on the upward stroke and
may chip the uppermost surface or edges of your
work piece. When cutting, ensure your uppermost
surface is a non-visible surface when your work is
finished.
MAINTENANCE
Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts
in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry
place. Keep the motor ventilation slots clean. Keep
all working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This is
normal and will not damage your power tool. If the
supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice. For
further information visit www.recycle-more.co.uk.
18
7
24
4
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8-1
Fig. 8-2
