Erbauer ERB180C, Manual, Page: 8 / 12

OPERATION INSTRUCTIONS
WARNING:
Before using your tile gutter
be sure to read the instruction manual
carefully.
1. FITTING THE PARALLEL GUIDE
(see fig1)
Position the parallel guide on work table as
shown. Align the holes in the fixing plates with
the holes in the upright ends of the parallel guide,
fix it with the four securing knobs provided. See
fig1.
Note:
The fixing plate should be fitted on the
inside surface of the work table edges.
Note:
Before use, the blade guard bracket and
blade guard must be fitted to the cutter.
2. OPERATING-STARTING AND STOPPING
(see fig2)
To start the cutter, plug mains lead into mains
supply. Press rocker switch to right to start
(marked “I“ on switch). Press rocker switch to left
to stop (marked “O” on switch, see fig2).
3. FILLING THE WATER TRAY WITH WATER
(see fig3)
Before the cutter can be used the water tray
must be filled. When removing machine from
packaging, the water tray is stored inside the
main housing.Remove it (see fig3). Fill the tray
to 3/4 full with water. Do not add chemicals or
detergents to the water.
4. MAKING A STRAIGHT CUT
(see fig4,5)
Adjust the guide to the desired width from the
blade using the scale rules on the table surface
for reference. To loosen and adjust, use the four
securing knobs (see fig4).
Position the tile firmly against the side fence and
pass through the blade in a smooth action. Do
not force the tile to be cut too quickly (see fig5).
5. MAKING A MITRE CUT
(see fig6)
Follow the same procedure for a straight cut but
employ the mitre guide in conjunction with the
parallel guide (see fig6). The mitre guide simply
runs up against the edge of the parallel guide.
Ensure that the tile is held firmly into the guide
before making the cut.
Fig 2
Fig 1
Fig 4
Fig 3