Erbauer ERB109SDR, Manual, Page: 11 / 17

900W BELT SANDER
OPERATION INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
1. ON/OFF SWITCH (See Fig A)
Depress to start and release to stop your tool.
2. SWITCH LOCK-ON BUTTON (See Fig A)
Depress on/off switch then lock on button. Your
tool is now locked on for continuous use. To
switch off your tool just depress and release the
on/off switch.
3. VARIABLE SPEED CONTROL DIAL
(See Fig B)
Adjust the variable speed control dial to increase
or decrease the speed according to the material
and sanding belt specification to be used (also
possible during no load operation). See the table
below for general guidance on speed selection.
Avoid prolonged use at very low speed as this
may damage your sander’s motor.
Material Speed
selection
Belt Grit
Solid Wood 5-6 80
Veneer 2-4 150
Chipboard 1-5 60/80
Plastics 2-5 100
Steel 5-6 80
Paint Removal 6 40/60
Balsa Wood 1-3 100
Acrylic 1-2 100
Generally the higher the grit size the lower the
speed is best practice
4. HAND GRIP AREAS (See Fig C)
Always hold your belt sander firmly with both
hands when operating.
5. CHANGING A SANDING BELT SANDER
(See Fig D, E)
WARNING! Remove the main plug
from the socket before changing Fig D
Fig A
Fig B
Fig C