1
2
2
OPERATION INSTRUCTIONS
Note:
Before using the tool, read the
instruction book carefully.
1. Adjusting the auxiliary handle (See Fig
1)
For your personal safety we recommend using
the auxiliary handle at all times.
To adjust the handle, loosen the handle lock knob
anti-clockwise. Rotate the handle around the
handle collar and/or rotate the handlebar to the
desired position as shown in Fig 1. Tighten the
lock knob fully.
2. Fitting the chisel (See Fig 2)
Clean the chisel shank and apply grease before
installing the chisel. Hold the rotary grip, pull
back the lock sleeve and insert the tool into the
chisel holder. Turn the chisel and push it in until a
resistance is felt, the shaft drops completely into
the chisel holder. Once you are satisfied it has
seated, release the black lock sleeve. This should
lock the tool into position.
After installing always make sure that the tool is
securely held in the chisel holder by trying to pull
it out.
If the tool is not located, repeat the installation
operation again.
3. Remove the chisel (See Fig 2)
To remove the tool, pull back the lock sleeve, hold
and pull the tool out.
4. Operating the On / Off switch (See Fig 3)
Press the on/off switch in for operation and
release to stop.
5. Chiseling operation
Position the chisel at the desired location. Then
switch on the machine. Do not force the tool.
Light pressure will gives best result.
6. Dust collector (See Fig 4)
Use the dust collector to prevent dust from falling
over the tool or on yourself when performing
overhead operations. Attach the dust collector to
the chisel as shown in Fig 5.
Fig 2
Fig 1
Fig 4
Fig 3
PDH150B-M-070927.indd 10
2007-9-27 11:19:50
