23
22
head (8) could damage sensitive bark, and damage fence posts (Fig. J).
Carefully manoeuvre the product around objects, such as trees and bushes, ensuring it
does not come into contact with them.
OVERLOAD, TEMPERATURE AND CHARGING PROBLEM
PROBLEM
TOOL / BATTERY
STATUS
POSSIBLE
CAUSE
SOLUTION
Overload
protection
Product suddenly
stops
Extremely high
torque, binding and
stalling situations,
overloading of the
tool
Relieve the load immediately,
reset the tool by switching off
and back on again.
Temperature
extremely
high
The first and the
third LED light of the
POWER BAR will be
flashing altemately
Battery
temperature
exceeds 77°C
during operation
Cool down the battery to
below 77°C for operation and
below 57°C for charging.
Low charge
Power for the tool
will drop quickly;
The first LED on
the POWER BAR
begins to flash
The battery pack is
under 5% charge
Remove the battery pack
from the tool and charge it
Other
problems
Short charges
Not fully charged
Make sure that battery is
fully charged every time
by allowing the charger to
complete its full charging
cycle
Poor storage
condition
Always remove battery from
the tool and charger when
not in use and store in a dry
secure place.Avoid charging
of storing your battery in
temperatures below 5°C and
above 40°C. Cool down a
hot battery pack from a tool
that has just been operated
for approximately 30 minutes
before storage
CARE & MAINTENANCE
WARNING!
Always switch the product off, remove the battery pack and
let the product cool down before performing inspection, maintenance and
cleaning work!
Only perform care and maintenance work according to these instructions!
All further works must be performed by a qualified specialist!
LINE SPOOL ASSEMBLY
REPLACEMENT(K-M)
NOTE:
Always use the recommended nylon cutting line spool assembly
with a diameter that does not exceed 2.0 mm. Using line other than that
specified may cause the brush cutter to overheat or become damaged.
WARNING!
Always use original spare parts for replacement.Do not
attach any other type of cutting device!
Press the two release buttons on the spool body and pull the spool retainer out (Fig. K).
Place a new spool into its retainer with notches aligned with retainer eyelets (Fig. L).
Align the retainer slots with the tabs on the spool base and press the retainer evenly
down, ensuring that it snaps into place. (Fig. M)
NYLON LINE REWIND
Take out approximately 5m of new nylon cutting line with a diameter of 2.0mm.
Form a loop at the middle of the line and insert this loop into the hook on the spool, with
one end of the line extending about 110 mm more than the other (Fig. N1).
Wind the two parts of the trimming line in a anticlockwise direction firmly around the
spool. Ensure each part of the line is either side of the guide on the spool(Fig. N2).
Wind all nylon line just leaving 120mm length then place the line ends through the two
opposite notches in the spool (Fig. N3).
WARNING!
Ensure each part of the line is not across with each other.
Otherwise that may cause the line feeding problem (Fig. O).
GUARD
Keep the trimming guard clean and free of debris. Remove trimmings.
