29
28
CARE & MAINTENANCE
WARNING!
Always switch the product off, remove the battery pack and
let the product cool down before performing inspection, maintenance and
cleaning work!
Only perform care and maintenance work according to these instructions!
All further works must be performed by a qualified specialist!
BLADE REPLACEMENT
WARNING!
Wear safety gloves when working on the cutting device and
close to it! Use appropriate tools to remove debris e.g. a brush or wooden
stick! Never use your bare hands!
Always use original spare parts for replacement. Do not attach any other
type of cutting device!
Keep the cutting blade (13) clean and free of debris. Remove trimmings.
Replace the cutting blade (13) with a one of the same type when it is worn or shows
damage.
Refit the blade to the spindle as described in section “
ASSEMBLING THE MACHINE
–
BLADE ”.
LINE SPOOL ASSEMBLY REPLACEMENT(FIG. L1-L3)
NOTE:
Always use the recommended nylon cutting line spool assembly
with a diameter that does not exceed 2.0 mm. Using line other than that
specified may cause the brush cutter to overheat or become damaged.
WARNING!
Always use original spare parts for replacement. Do not
attach any other type of cutting device!
Press the two release buttons on the spool body and pull the spool retainer out (Fig. L1).
Place a new spool into its retainer with notches aligned with retainer eyelets (Fig. L2).
Align the retainer slots with the tabs on the spool base and press the retainer evenly
down, ensuring that it snaps into place (Fig. L3).
NYLON LINE REWIND
Take out approximately 5m of new nylon cutting line with a diameter of 2.0mm.
Form a loop at the middle of the line and insert this loop into the hook on the spool, with
one end of the line extending about 110 mm more than the other (Fig. M1).
Wind the two parts of the trimming line in a clockwise direction firmly around the spool.
Ensure each part of the line is either side of the guide on the spool(Fig. M2).
Wind all nylon line just leaving 120mm length then place the line ends through the two
opposite notches in the spool (Fig. M3).
WARNING!
Ensure each part of the line is not across with each other.
Otherwise that may cause the line feeding problem (Fig. N).
GUARD
Keep the trimming guard (18) and blade guard (14) clean and free of debris. Remove
trimmings.
Replace the trimming guard (18) and blade guard (14) with one of the same type when it
is worn or shows damage.
CLEAN
• Clean the product with a dry cloth. Use a brush for areas that are hard to reach.
• In particular clean the switches and air vents after every use with a cloth and brush.
• Remove stubborn dirt with high pressure air (max. 3 bar).
• Check for worn or damaged parts. Replace worn parts as necessary or contact an
authorised service centre for repair before using the product again.
NOTE:
Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be harmful to
its surfaces.
MAINTENANCE
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool.
Before and after each use, check the product and accessories (or attachments) for wear
and damage. If required, exchange them for new ones as described in this instruction
manual. Observe the technical requirements.
TRANSPORTATION
WARNING!
Always carry the product by its main handle.
Never use the cord for carrying the product.