37
ECSP51
In
more
detail
. . .
Engine cold start
1. Place the saw where it does not come into contact with any objects.
2. Engage the chain brake.
3. Press the primer (7) until the bubble is filled with fuel (6 times) (Fig. 20).
4. Set the choke (13) to CLOSE position (Fig. 21).
20
7
21
13
5. Hold the product securely to the
ground. Place your left hand on the
front handle (5) and additionally
secure the product with your right
foot (Fig. 22).
6. Pull the recoil starter handle (14)
slowly with your right hand until you
feel a definite resistance and then
give it a brisk, strong pull. Repeat
until the engine attempts to start but
no more than 4 times.
7. If the engine does not start, set the
choke (13) to OPEN
position.
8. Pull the recoil starter handle (14)
briskly and strongly. Repeat until the engine starts.
9. Squeeze the throttle trigger lock-out (8) and throttle trigger (10) and release them.
10. Let the product run in idle for 1 to 2 minutes to let it warm up.
11. Disengage the chain brake.
12. To start cutting, grip the product with both hands, left hand holding the front handle (5)
and the right hand holding the rear handle (9).
22
5
14
Operation
