p 3
Eraser Company Inc. • Syracuse, NY USA • Ph: 315-454-3237 • [email protected] • www.eraser.com • Fax 315-454-3090
GENERAL INSTRUCTIONS
REMOVE ADJUSTING KEYS AND WRENCHES.
Verify that keys and adjusting wrenches are
removed from tool before turning on.
KEEP WORK AREA CLEAN.
Cluttered areas and
benches invite accidents.
DON’T USE IN DANGEROUS ENVIRONMENTS.
Don’t use power tools in damp or wet locations, or
expose them to rain. Keep work area well lighted.
ALWAYS USE SAFETY GLASSES.
Everyday
eyeglasses only have impact resistant lenses; they
are NOT safety glasses. Also use face or dust mask
if cutting operation is dusty.
WEAR PROPER APPAREL.
Do not wear loose
clothing, gloves, neckties, rings, bracelets, or other
jewelry that might get caught in moving parts.
Nonslip footwear is recommended. Wear protective
hair covering to contain long hair.
DON’T OVERREACH.
Keep proper footing and
balance at all times.
MAINTAIN TOOLS WITH CARE.
Keep tools sharp
and clean for best performance and to reduce the
risk of injury. Follow instructions for lubricating and
changing accessories.
DISCONNECT TOOL
before servicing; when
changing accessories, such as blades, wheels,
cutters, and like.
USE RECOMMENDED ACCESSORIES.
Consult the operating manual for recommended
accessories. The use of improper accessories may
cause risk of injury to persons.
CHECK DAMAGED PARTS.
Before further use
of the tool, a guard or other part that is damaged
should be carefully checked to determine that it will
operate properly and perform its intended function.
Check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting, and
anyotherconditionsthatmayaffectitsoperation.
A guard or other part that is damaged should be
properly repaired or replaced.
DO NOT EXCEED THE MAXIMUM MATERIAL
SPECIFICATIONS.
DO NOT OPERATED UNIT WITHOUT GUARDS
IN PLACE OR GUARDS NOT IN WORKING
ORDER.
DO NOT PERFORM MAINTENANCE OR
ADJUSTMENTS WITH POWER ON.
DO NOT PLACE FINGERS OR APPENDAGES
IN OR NEAR OPENINGS IN GUARDS.
DO NOT RUN UNIT WITH INCORRECT LINE
VOLTAGE. REFER TO LABEL PLACED OVER I/O
SWITCH.
DO NOT ALLOW UNTRAINED OR UNQUALIFIED
PERSONNEL TO OPERATE UNIT.
DO NOT DEFEAT ANY OF THE SAFETY
FEATURES
DESIGNED INTO THE UNIT.
IMPORTANT:
NO LIABILITY WILL BE INCURRED BY THE
ERASER COMPANY FOR INJURY, DEATH, OR
PROPERTY DAMAGE CAUSED BY A PRODUCT
WHICH HAS BEEN SET UP, OPERATED, AND/OR
INSTALLED CONTRARY TO ERASER’S WRITTEN
OPERATING MANUAL, OR WHICH HAS BEEN
SUBJECTED TO MISUSE, NEGLIGENCE, OR
ACCIDENT, OR WHICH HAS BEEN REPAIRED
OR ALTERED BY ANYONE OTHER THAN
ERASER, OR WHICH HAS BEEN USED IN A
MANNER OR FOR A PURPOSE FOR WHICH THE
PRODUCT WAS NOT DESIGNED.
OPERATING INSTRUCTIONS
SET-UP:
The LFTC1 is supplied with one 3/32” Allen wrench,
one 9/64” Allen wrench, & one 5/32” Allen wrench.
Bushings must be purchased separately.
!
CAUTION:
The flexible tubing blade is intended
for use on soft flexible. However, some rigid
non-metallic tubing may be cut. The blade is
a very thin sharp blade and caution should be
used when handling it.
MODEL LFTC1 FLEXIBLE TUBE CUTTER
