PCB Layout
Battery
Tamper Switc
h
Zone Setting
Installation
1.
Carefully remove the activation strip from the battery
compartment.
2.
Remove the backing paper from one side of each
self-adhesive double-sided strip. Fix one strip to the
back of the Magnet and one to the back of the
Transmitter.
3.
Peel off the other side of each adhesive strip. Mount
the Magnet on the door and the Transmitter on the
door frame (small triangles facing each other), with less
than a 1 cm separation between the two.
4.
When opening the door a small red indicator lights up
briefly
, this indicates that the Transmitter has sent a
signal to the Control Panel.
Specification
2 x DC 3V Lithium Batteries (CR2032)
The Magnet can be
positioned either
side of the Sensor.
Power Supply
Transmitting Distance
≤ 80% (non-condensing)
0°C~55°C
71x 31.5 x 15 mm
71x 12.5 x 15 mm
ABS Plastic
Radio Frequency
Housing Material
Operating Temperature
Relative Humidity
Sensor Dimensions (L x W x D)
Magnet Dimensions (L x W x D)
Features
Appearance
Disarm
SOS
Part Arm
(Home Arm)
Arm
Status Indicator
The Remote Control enables you to quickly and
conveniently Arm and Disarm your Alarm System.
In the event of an emergency (when in or near your
property), pressing the SOS button will trigger an
alarm condition on the Control Panel/Siren.
Appearance
LED Indication
Flashes once:
transmits the signal
Low Light Level:
low battery indication, (immediate
battery change recommended)
Remote Control Buttons/Functions
See over.
Specification
Power Supply 1 x DC 3V (CR2025) Lithium Battery
Transmitting Distance
≤80m (in open ar
ea)
Radio Frequency
433 MHz
Housing Material
ABS Plastic
Operating Temperature
0°C~50°C
Relative Humidity
≤ 80% (non-condensing)
Dimensions (L x W x D)
58 x 31 x 9.5mm
Remote Control Buttons/Functions
Arm
Positioning
Install the Siren to the outside of the building in a position that is clearly visible and at a height which is relatively inaccessible to an
intruder.
The Siren is designed to work on any aspect wall, however for optimum performance try to avoid installing on a North facing wall or to a
wall with shadows cast by other buildings, trees and roof overhangs.
For optimum radio signal reception mount the Solar Siren at a minimum distance of one metre away from any external or internal
metalwork (drainpipes, gutters, radiators, etc).
Installation
Jumper Setup
PCB Layout
High (default)
Mute Low
5 minutes 2 minutes
30 seconds (default)
Rear
Anti-tamper
Switch
Sirens
Rear Cover Tamper Socket
Inner Tamper Switch
Learn Button
Status LED Indicator
Alarm LED Indicators
Volume Setting
Siren Duration Setting
Rechargeable 3.7V
1800mAh Lithium Battery
9V
Start-up
Battery
Disarm
Part Arm
(Home Arm)
Panic
Mute Arm
Mute Disarm
Press to activate a Panic Alarm (SOS). The Control Panel will auto-dial out to
the pre-set phone numbers immediately
Press to Arm the Control Panel/Siren and all of the Accessories (Full Arm)
Press to Disarm the System
Press to Part Arm the System (for Control Panel Systems only)
Press to Arm the System with the Solar Siren in Mute/Silent Mode
Press to Disarm the System with the Solar Siren in Mute/Silent Mode