Equus 250L, User Manual

Page: 5 / 15

Figure 2 Figure 3
Measure the distance between the ends of the two shaft (Dimension “A”, Figure 1). Each half of PTO should be equal
to Dimension “A” minus two (2) inches.
If the driveline must be cut to a shorter length, clamp driveline in a well-padded vise to prevent damage to the shield
(Figure 3). Cut the plastic shield 1-1/2” shorter than shafts.
Repeat the procedure to the other driveline half. Remove all burrs and cuttings.
Apply multi-purpose grease to inside of outer (female) driveline section. Assemble driveline and install on tractor and
spreader. Pull on each driveline section to be sure yokes lock into place. Make certain driveline shielding is in place
and in good condition.
NOTE: A PTO driveline that is too long and “bottoms out” could possibly cause severe damage to the gearbox. It is
VERY IMPORTANT to check the proper PTO driveline length for your tractor. Gearboxes damaged by incorrect PTO
driveline length are NOT covered by warranty.
NOTE: The use of a PTO shaft adapter or extension could require that the PTO driveline be shortened a considerable
amount. If this is done, the driveline halves may separate when the spreader is lowered to the ground.
CAUTION!
Do not operate this equipment without shields properly installed. This is for your protection, and the
manufacturer recommends the use of these shields all times.
When attaching PTO yoke to tractor PTO shaft, it is important that spring-activated locking pin slides freely
and is seated in groove on PTO shaft. A loose shaft could slip off and result in personal injury or damage to
equipment.
If your tractor has extra long lift arms, it may be necessary to use a PTO extension so that you can use the PTO shaft
assembly provided. Be sure the PTO assembly does not close too far (bottom out) if you use a PTO extension.
Never raise or lower the seeder/spreader so that the PTO shaft assembly will come apart.
A heavy load can cause instability in driving a tractor. Make sure the front of the tractor is property
counter-balanced with weights. Always drive slowly – especially around turns. An unstable tractor could steer
badly and possibly tip over, causing injury or death.
Fertilizers will vary as to weight and quality which may require additional adjustment by moving the individual fan
blades. Moving the blade tips forward will carry more material to the left side. Moving the fan blade tips back will allow
more material to be spread to be right. (See Figure 4)
Figure 4
Make small adjustment moves and check spread after each adjustment.
NOTE: The gearbox is filled with lubricant and sealed at the factory. If operated and stored properly, the gearbox will
provide a long, trouble-free service life. If disassembly that the box be re-filled with a good quality grease and that the
box halves are resealed with a silicone adhesive.
Obey All Safety Warnings!
4