Page 3
Page 4
Page | 2
.9-inch LED Alarm Clock
with USB Charging Port
Model: 30024 & 30025
DC: 011419
POWER UP
1. Insert the 120 volt power cord into an outlet, then into your
clock. Optional: Insert one 9 volt battery for backup.
2. 12:00 will flash as an indication to set the time and/or alarm.
TIME SETTING
1. Continuously hold down the TIME button, then:
•
Press the HOUR button to set your hour.
•
Press the MINUTE button to set your minutes.
Note:
The PM indicator will appear when you advance to PM time.
2. Release the TIME button when the correct time is shown on the
display.
USB CHARGING PORT
• Connect your external device’s USB charging cable
(not included) to the USB charging port.
• USB Power Output: 5V 1A maximum current.
• Charge devices that are self-regulating.
TIME ALARM
ON:
Slide the ALARM ON/OFF switch to the ON position to turn
the alarm ON. The alarm light indicator will appear.
OFF:
Slide the ALARM ON/OFF switch to the OFF position to turn
the alarm OFF. The alarm light indicator will disappear.
ALARM ON/OFF
1. Continuously hold down the ALARM button, then:
• Press the HOUR button to set your hour.
• Press the MINUTE button to set your minutes.
Note:
The PM indicator will appear when you advance to PM time.
2. Release the ALARM button when the correct alarm time is set.
SNOOZE
• When the alarm sounds press the SNOOZE/LIGHT button to
silence the alarm for 10 minutes.
• Snooze may be repeated.
Note:
This is a Ascending alarm. It will sound with increased
frequency for 2 minutes then shut off if no buttons are pressed.
• Always purchase the correct size and grade of battery most
suitable for ntended use.
• Clean the battery contacts and also those of your clock prior to
battery installation.
• Ensure the battery is installed with correct polarity (+ and -).
• Remove battery from equipment when it is not used for an
extended period of time.
• Promptly remove an expired battery.
CARE & MAINTENANCE
BATTERY BACKUP
• Insert one “9V” battery into the battery compartment on the back
of the clock. The battery will keep the alarm and time settings
until the power is restored.
• The LED display will not light-up but the alarm will sound at the
preset alarm time.
• If there is no battery installed but the power is interrupted, the
display will flash at 12:00 and the time and alarm need to be set
again.
Power:
120V power cord
Requires one 9V battery for back-up not included
Dimensions:
5.00 ”W x 2.00”D x 2.85”H
POWER REQUIREMENTS
BACKLIGHT
Your backlight has three levels: High, Low , and Off.
•
Press the SNOOZE/LIGHT button to adjust.
