INSTALLATION
The
SODIR
warmer needs to be connected to a grounded 120V outlet. DO NOT
place the unit in a damp area or near steam sources. Do not block ventilation holes.
The warmers require 1 inches of clearance from walls or combustible materials.
DO
NOT ADD WATER TO THE HEATING CHAMBER(S)!
Warming is accomplished
without the use of water.
ASSEMBLY
The SODIR warmer comes from the factory completely assembled. Prior to
operation, the unit should be cleaned using a soft cloth dampened with a solution of
soap and water. Be sure not to drip any water into the base, or ventilation cutouts.
The plastic containers should be washed before first use.
OPERATION
Preheating
DO NOT ADD WATER TO THE HEATING CHAMBER(S)!
Warming is
accomplished without the use of water.
First, fill your bottle(s) ¾ full with your selected
topping(s), and place in the heating chamber(s). If you wish to thin your mixture you may mix
a tablespoon of nut oil with it, prior to filling the bottle.
The single warmer has a push button power switch; the drop-in warmer has an integrated
power switch/thermostat, which is activated by turning the knob clockwise; and the double unit
uses both push button power switch and the thermostat knob. When the unit is powered on,
the green light will turn on. To preheat the warmer after cleaning and assembly, push in the
power switch (if equipped), rotate the thermostat to the max heat setting and set the
provided timer for 15 minutes. The simple timer included has buttons for minutes,
seconds and start/stop. The units require this time to properly preheat. If using the double
warmer, the front chamber can be used alone, and will heat when the knob is rotated
clockwise. The rear chamber will heat if the push button switch is pushed in, but only while
the thermostat knob is turned on as well. The rear chamber cannot operate alone, but heats
along with the front chamber.
Operation
Once the timer signals the end of the preheating cycle, rotate the thermostat knob counter-
clockwise to the desired heat setting, generally between 120
0
and 140
0
F. The unit will
continue to operate until the knob is rotated fully counter-clockwise to the
“off” position, and
the push button, if equipped, is in the off/out position.
The SODIR warmer can be used for a wide variety of toppings. Holding temperature will
vary depending on topping, desired results and health code requirements.