www.prolight.co.uk
Scantastic 4
User Manual
5
Operating instructions
Master/slave mode:
To set the master unit, press the
“MENU”
button on the rear of the master unit to show
SLNd
on
the LED display. Press the
“ENTER”
button and use the
“UP”
and
“DOWN”
buttons to select
Nast
.
Press the
“ENTER”
button to confirm the setting and then select your desired program.
To set the other units in slave mode, press the
“MENU”
button on the rear of the unit to show
SLNd
on the LED display. Press the
“ENTER”
button and use the
“UP”
and
“DOWN”
buttons to select
sL-1
.
Press the
“ENTER”
button to confirm the setting. The units will now run in sequence with the master unit.
To exit out of any of the above options, press the
“MENU”
button.
Please ensure that all slave units are set to the same DMX channel mode as the master unit.
Sound active mode:
To access sound active mode press the
“MENU”
button until the display shows
SOUN
on the
LED display. Press
“ENTER”
to confirm the setting. Use the
“UP”
and
“DOWN”
buttons to set sound
active mode to
on
or
off
. Press the
“ENTER”
button to confirm the setting. T
To adjust the sound sensitivity use the sound sensitivity adjustment knob on the rear of the unit.
To exit out of any of the above options, press the
“MENU”
button.
Please note:
When there is no sound present the unit will automatically switch to slow auto run
LED display timeout:
To access LED display timeout press the
“MENU”
button until the display shows
Led
on the
LED display. Press
“ENTER”
to confirm the setting. Use the
“UP”
and
“DOWN”
buttons to select
between
on
or
off
. Press the
“ENTER”
button to confirm the setting.
To exit out of any of the above options, press the
“MENU”
button.
Display mode:
To access the display mode, press the
“MENU”
button on the rear of the unit to show
dISP
on the
LED display. To flip the display press the
“ENTER”
button and use the
“UP”
and
“DOWN”
buttons to
select
dSIP
. Press the
“ENTER”
button to confirm the setting.
To exit out of any of the above options, press the
“MENU”
button.
Test mode:
To test that all the LEDs are illuminating, press the
“MENU”
button on the rear of the unit to show
test
on the LED display. Press the
“ENTER”
button to start the test. Once you are satisfied with the
test press the
“ENTER”
button to stop it.
To exit out of any of the above options, press the
“MENU”
button.
Fixture hours:
To access the fixtures hours, press the
“MENU”
button on the rear of the unit to show
hour
on the
LED display. Press the
“ENTER”
button to show the total hours the fixture has been used for.
To exit out of any of the above options, press the
“MENU”
button.
Operating instructions