Daisy Chain Connection
1) Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin
connector of the first fixture
2) Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector.
Proceed to connect from the output as stated above to the input of the following fixture
and so on.
DMX Control Mode
Operating in a DMX control mode environment gives the user the greatest flexibility when it comes
to customising or creating a show. In this mode you will be able to control each individual trait of the
fixture and each fixture independently. The Equinox RGB 1.5M DMX Flame Machine uses 6 channels of
control.
Enable the DMX control by setting dip switch No: 10 to the
ON
position. Use dip switches 1 – 9 to
address each fixture accordingly.
Setting the DMX address
The DMX mode enables the use of a universal DMX controller. Each fixture requires a “start address”
from 1- 511. A fixture requiring one or more channels for control begins to read the data on the channel
indicated by the start address. For example, a fixture that occupies or uses 7 channels of DMX and was
addressed to start on DMX channel 100, would read data from channels: 100,101,102,103,104,105 and
106. Choose a start address so that the channels used do not overlap. E.g. the next unit in the chain
starts at 107.
Input from DMX controller
Use 3-pin XLR DMX cable
Use 3-pin XLR DMX cable
Control options
Summary of Contents for RGB 1.5M DMX
Page 1: ...USER MANUAL RGB 1 5M DMX Flame Machine...
Page 2: ...Safety...
