●
Defective seal on plunger.
●
Over filling container.
◇
Replace plunger.
◇
Follow instructions in owner’s
manual.
Noisy pump assembly.
●
Impellers not properly shimmed or
rubbing.
●
Pump parts not properly installed.
●
Debris in bottom of tub sump area.
●
Defective motor bearings.
◇
Use shim gauge furnished in
impeller and seal kit, when seals
are properly shimmed the
impellers will be in correct
operating position.
◇
Inspect and correct.
◇
Clean out sump area.
◇
Replace motor.
Dishwasher continues to fill
or continues to fill even
though in case of there is no
voltage to fill valve.
●
Something (dirt or foreign
material) under diaphragm in water
inlet valve.
●
Defective water inlet fill valve.
◇
Clean water inlet valve or
replace.
◇
Replace water inlet valve.
Detergent left in dispenser.
●
Detergent cup held or blocked by
large dishes.
●
Dispenser wet when detergent
was added.
◇
On proper loading dishes.
◇
Instructs customer/user.
Softener leaking
●
Softener broken.
●
Softener nut loosen.
◇
Replace softener.
◇
Screw down softener cap.
Leaking form air inlet.
●
Air inlet nut loose.
●
Air inlet install up side down.
◇
Screw down air inlet nut.
◇
Reinstall air inlet properly.
Window Display “E1”
●
Inlet Valve Damaged.
●
Inlet Valve Disconnected.
◇
Replace Inlet Valve.
◇
Reconnected Line.
Window Display “E2”
●
Pressure Switch Damaged.
◇
Replace Pressure Switch.
Window Display “E3”
●
Heating Element (open).
●
Power Supply To heating Element
Cutting.
◇
Replace.
◇
Reconnect Line.
Window Display “E4”
●
Float Switch Act.
◇
Take Remove The Rubber Cap
Let Water Pour Out.
Window Display “E5”
●
Thermostat Sensor Damaged.
◇
Replace sensor(See figure8).
13
