UNPACKING AND INSTALLING THE DOOR HANDLE
Remove the exterior and interior packing materials.
Install the door handle provided with the appliance by following
these steps:
1. Remove the gasket at the inner side of the door to expose
the two screw holes.
2. Install the handle tightly with the screws and washers provided.
3. Replace the gasket.
INSTALLATION INSTRUCTIONS
Before Using Your Appliance
Remove the exterior and interior packing.
Before connecting the appliance to the power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Use a soft cloth to clean the interior surface with lukewarm water.
This appliance is intended for household use.
When disposing your appliance, please choose an authorized disposal site.
Installation of Your Appliance
This appliance is designed to be freestanding or built-in (fully recessed). (Refer to sticker location at the back of
this appliance).
This appliance is intended to be used exclusively for the storage of wine or beverages.
Place your appliance on a flat floor that is strong enough to support it when it is fully loaded. To level your
appliance, adjust the front leveling legs at the bottom of the appliance.
This appliance is using flammability refrigerant. So never damage the cooling pipework during the
transportation. Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme
cold ambient temperatures may also cause the unit not to perform properly.
Avoid locating the unit in moist areas.
Plug the appliance into an exclusive, properly installed-grounded wall outlet. Do not cut or remove the third
(ground) prong from the power cord under any circumstances. For any questions concerning power and/or
grounding consult a certified electrician.
Attention
Do not overload the cabinet
Do not open the door unless necessary
Do not cover shelves with aluminum foil or any other shelf material which may prevent air circulation
If the appliance is not used for long periods, it is suggested to leave the door ajar to allow air to circulate inside
the cabinet after a careful cleaning, to avoid condensation, mold or odors.
3
Handle
Lock Washer
Flat Washer
Door Frame
Screw
Gasket
