OPERATION INSTRUCTIONS FOR THE EQUALIZER® EQ2 REGISTER
BOOSTER™
READ AND SAVE THESE INSTRUCTIONS
With the use of any electrical appliance, it is important to observe all basic
precautions to minimize the risk associated with use, such as electrical shock, fire, or
injury to persons. Read these instructions before using your Equalizer® EQ2
Register Booster™.
NEVER EXPOSE YOUR EQUALIZER® EQ2 TO TEMPERATURES OVER
140°F (60°C)
INSTALLATION
FLOOR REGISTERS
1. Follow the directions for Operation Settings.
2. Position the Equalizer
®
EQ2 over any 6" x 12" (or smaller)
register.
3. Plug the power cord into the nearest 110-120 Volt AC outlet..
WALL REGISTERS
In some instances, when wall mounting the Equalizer
®
, the lettering on the Control Panel
label will be upside down.
1a. Installing over an existing register grill (see figure 1)Using the template, mark the
screw hole positions and then install two #6 screws (not included) into the top frame of
the register grill. Leave 7/16" of the screw protruding.
Figure 1
Figure 2
1b. Installing over a register boot without a register grill (see figure 2 above).Using the
template, mark the screw hole positions and then install two #6 screws not (not included)
above the edge of the register boot (plastic expanding plugs may be needed). Leave 7/16"
of the screw protruding from the wall surface.
