SECURE-GRIP IN-LINE HYDRAULIC FLANGE SPREADERS
OPERATOR INSTRUCTION MANUAL
PAGE 27
CLOSE RELEASE
VALVE
OPEN RELEASE
VALVE
NUTS
MAIN
HANDLE
RVHVDUHFRQQHFWHGDQGWKHWRRODGYDQFHVDVWKHSXPSLVSULPHGEXWWKHSUHVVXUHRQWKHSXPSKDQGOHLV
xxxxxxxxx
minimal and feels spongy
¬
$LUFRXOGEHSUHVHQWLQ
the hydraulic system
Use the airlock removal
procedure as follows:
1.
Connect the hand pump to the
tool with the hydraulic hose
2.
Close the release valve on the
pump, and prime the pump
until the hydraulic cylinder
is fully extended and a small
pressure is achieved
3.
With the hand pump held
DERYHWKHWRRODQGWKHWRRO
in an upright position, open
the release valve causing any
air that is within the system
WREHIRUFHGXSWKURXJKWKH
pump and vented into the oil
reservoir
4.
Repeat steps 1 - 3 three or
four times to ensure that all air
is removed from the system
and the tool will reach full
working pressure
5.
Disconnect the hand pump
from the hydraulic hose, grip
WKHEDVHSODWHRIWKHKDQG
SXPSERG\LQDYLFHZLWKWKH
SXPSERG\YHUWLFDODQGWKH
main handle at the top
6.
Remove the four nuts holding
the main handle and lift off
7.
*ULSWKHUH¿OOLQJSOXJZLWK
SOLHUVDQGH[WUDFWLWE\SXOOLQJ
and twisting simultaneously.
(QVXUHWKHUHVHUYRLUERG\LV
held down when removing the
UH¿OOLQJSOXJDVSXOOLQJXSRQ
WKHUHVHUYRLUERG\ZLOOUHOHDVH
WKHEODGGHUZLWKLQDQGRLOZLOO
spill out.
8.
Fill the reservoir to the top with
a good quality hydraulic oil of
the grade 15 cSt
9.
5HLQVHUWWKHUH¿OOLQJSOXJZLSH
DZD\DQ\RLODQGUHDVVHPEOH
E\UHYHUVLQJWKHGLVDVVHPEO\
process
Summary of Contents for SG18TE
Page 2: ......
