QX5
QXFXO4/QXISDN4/QXE1T1/QXFXS24; (SW Version 6.0.x)
32
QXFXO4/QXISDN4/QXE1T1/QXFXS24 Manual II: Administrator’s Guide
General Operation Mode
The
General Operation Mode
page provides the option of setting up a
corresponding mode for the QXFXS24 gateway.
The
General Operation Mode
radio buttons are as follows:
•
The
Stand-alone mode
selection configured the device manually
from its own GUI. In this mode the device is used as a standalone
gateway.
•
The
PNP Mode
selection
getting the device configuration from
another QX IP PBX unit. Some configuration values could be
altered manually if needed.
Fig.II- 33: QXFXS24 General Operation Mode page
FXS Lines
FXS (On-board) Line Settings
The
FXS (On-board) Line Settings
page is used to configure QX lines and to define the caller ID detection type, configure remote party disconnect
indication and select the ringer type on each of them. Additionally this page provides an option to enable Loopback diagnostics on the lines.
The
Onboard Line Settings
page shows the table
Available
Lines
where all active lines of QX are listed (QXFXS24 has 24 active lines)
with their
Attached Extension
. If the line is attached to an extension,
the corresponding extension number is displayed in this column;
otherwise “none” is displayed if the extension is not attached to the
line. By clicking on the extension number, the
page will appear, where the line attached to the
extension can be reconfigured. Additionally, the table provides
information about the selected
Ringer Type
and
Caller ID
detection
method that is configured for the selected line. The caller ID detection
method is different for various types of phones and can be found in the
phone manual.
When pressing on the line number under the
Available Lines
column
,
the
FXS
On-board Line Settings
page specific for the current line is
opened and offers the following input options:
Fig.II- 34: FXS Line page
The
Caller ID
drop down list contains various standards of Caller ID
transmissions. It is used to send the calling party's information to the
phone attached to the selected line:
•
No Caller ID.
•
FSK, send prior to the first ring.
•
FSK, send between the first and second ring.
•
FSK, send both prior to a ring and between the first and second
ring.
•
DTMF, send prior to the first ring.
•
DTMF, send between the first and the second ring.
•
Combined, send both DTMF prior to the first ring and FSK
between the first and the second rings.
The QX sends the current time/date to the called phone together with
the caller’s information.
Fig.II- 35: Line Settings – Line# page
