JA02132020
U
-00153
7
Connect edge trim frames (
e/f
) together using the
Center Joints- M4(a)
and secure with four of the
M4x4 Screws (m)
as shown in
Step 1
. Repeat for other side.
Once both top and bottom edge trim frames have been connected, attach the vertical (left/right) sides edge trim
frames (
d
) using the
Elbow Joints M4(c)
and secure with four
M4x4 screws
(
m
) on all corners,
Step 2
.
Step 11
: Install the
angle cover
(
n
) on each corner of the frame as show in the illustration below.
Step 12
: Install the
springs (q)
in each middle area to secure the bezel trim edge frame.
Notice to Installer:
Please use the following installation instructions to obtain superior optical performance from the Polar Star®
Angular Reflective ALR
(Ambient Light Rejecting)
Screen.
• Angular-Reflective material is not compatible with ultra/short-throw projectors
• Minimum lens throw ratio 1.5x image width
• Ambient light must not come from the same direction as the projector
Since angular-reflective means that the projected image will reflect at the mirror-opposite angle, it is important to
position the projector so that the viewer will get the best possible image.
Step 1:
Establish the general “eye level” of the viewers
Step 2:
Set the appropriate projection level
Step 3:
Adjust the screen height level and projection angle
Input Angle
(A) = Output Angle (B) aligns with the viewer’s angle
c.
a.
m.
2.
1.
1.
2.
2.
screen
sc
re
en
2.
1.
m.
.
1.
2.
2.
o.
Peel off the double-sided tape.
h.
