12282021JA
7
Step 14:
Insert the
Center Support Bar (i)
into the upper top groove on the back of the frame with the
bottom end near the approximate center point of the frame and rotate it in at an angle so that both ends of
the bar are in alignment with the groove.
Diagonal Models 150” and below use 1
x Center Support Bar
Diagonal Models above 150” require 2
x Center Support Bars
Attention: Do not proceed with the Edge Trim installation until making sure there are no ripples
in the material.
Edge Trim Installation
Step 15
: Place the
Edge Trim
over each end of the frame and secure with
M4x6screws (c)
.
Start with the center points first, then the rest of the corners as shown below.
1
1
2
2
2
2
