V120617-ESC100
6
Step 10:
Use the
spring hook (d)
to attach the
spring (e)
to the hole located on the screen material’s outer edge
in the following order.
Make sure the spring hook goes over the rod
.
Attach the four corners first (1).
After those are secure, connect the vertical portions of the material, begin in the center and move towards the
corners (2). Lastly, connect the horizontal sections of the material by connecting the center of the material and
make your way towards the corners (3).
Note (after all springs have been attached):
Correct material installation
–Corners of the screen material are properly wrapped around the corner edges of
the frame and material is evenly tensioned and flat, creating a nicely taut surface.
Incorrect material installation
–The corners of the screen material are not properly wrapped along the edge of
the frame leaving the material with unbalanced tension and an uneven finish. To correct, detach springs from
material at the corner(s) where material does not lie flat along the edge of the frame, reposition the material so
that it lies flat and wraps along the edge of the frame, and reattach springs to the material.
To avoid ripples forming in the material it is imperative that all the corners are properly wrapped around the
edges as illustrated in the check mark diagrams above.
1
1
1
1
2
3
2
3
Attach springs to holes
Repeat on all sides
