Epson TM-P20, Technical Reference Manual

Page: 75 / 100

75
Chapter 5 Handling
5
Handling
This chapter describes basic handling of the printer.
Charging Battery
There are 4 ways to charge the battery:

using the printer itself with the single charger (OT-SC20)

using the printer itself with the quad charger (OT-MC20)

using the battery spacer (OT-BS20) with the single charger (OT-SC20)

using the battery spacer (OT-BS20) with the quad charger (OT-MC20)
WARNING
Be sure to use the battery BT-BY20.
Using a battery other than the one specified may cause fire, explosion, leakage, overheating or other
damage.

The battery can be charged only when the temperature is 0 ~ 40°C {32 ~ 104°F}.

Dispose of used batteries according to the instructions.

Do not remove the battery during charging.

Fully charging a battery that is fully discharged will take approximately 3 hours.

Charging the battery at 35°C {95°F} or higher may require a longer charging time than the specified
one.

The Charge LED turns off when charging is not occurring.

You can use the printer during the battery charging.

For information on the battery spacer (OT-BS20), see its User’s Manual.

For information on the optional quad charger (OT-MC20), see its User’s Manual.