Item
Parameter
Explanation
Tension Measurement
Periodically
Choose
Periodically
or
Every Page
to have the printer automatically
monitor and adjust media tension during printing for optimal results,
Off
to disable automatic tension adjustment.
Periodically
is recommended in most circumstances.
The printer may however be unable to adjust tension appropriately for
some media, resulting in excessive slack or other maladjustments that
cause printing problems, in which case you should select
Off
. Note,
however, that
Off
may result in unusually large margin between pages. In
addition, printing may not stop and the inside of the printer may become
stained. Observe the following precautions:
❏
Do not print at the end of a roll
❏
Do not select
Off
for Media End Check.
Select
Every Page
for more precise tensioning, but note that print times
will increase.
Every Page
Off
Media Tension
0 to 40
Increase tension if creases appear in the media during printing. The higher
the value, the greater the tension.
The manufacturer default set values will change as follows depending on
the
Tension Measurement
setting.
Periodically
/
Every Page
: Level 15
Off
: Level 25
Feed Speed
1 to 2
Choose a slower feed speed if thin media is creased or torn or sticks
together during printing. The lower the value, the slower the speed.
Print Media List
Parameter
Explanation
Print the contents of media setting banks 1 to 30.
Printer Setup Menu
indicates default settings.
Item
Parameter
Explanation
Side Margin(Right)
3 to 25 mm (0.12 to
1.00 inch)
Choose the width of the right margin when media is loaded in the printer.
See the following for more information.
U
Side Margin(Left)
3 to 25 mm (0.12 to
1.00 inch)
Choose the width of the left margin when media is loaded in the printer.
See the following for more information.
U
SC-F7000 Series User’s Guide
Using the Control Panel Menu
73
