Maintenance
82
When printing is complete, the media will automatically be fed to a position where the
pattern is clearly visible.
Cut the media if necessary. See “Cutting Media” on page 50.
4. Inspect the nozzle pattern.
Example of clean nozzles:
The pattern contains no gaps.
Example of clogged nozzles:
Perform head cleaning if any segments are missing from the pattern. See
5. The menus close when printing is complete.
Head Cleaning
Should the nozzle pattern contain faint or missing segments, you may be able to unclog the
nozzles by cleaning the print head as described below.
There is no need to clean the head if the print result does not contain faint areas or other
color problems.
You can also clean the head while printing is paused. Note, however, that hues in the
printout may change when printing is resumed.
Note:
To rewind the media, press
u
. Stop rewinding before the media is past the cutter groove
(on the pressure roller side).
If the leading edge of the media is curled, stop rewinding before the media reaches the
inner side of the front cover.