81
Checking for Clogged Print Head Nozzles
Cleaning the Print Head
Aligning the Print Head
Performing Head Maintenance
Parent topic:
Checking for Clogged Print Head Nozzles
To maintain optimum print quality, perform a nozzle check before printing. This lets you visually inspect
the printed check pattern and clean the nozzles, if necessary.
There are two ways to check the nozzles:
• Set up the product to automatically print a check pattern before each print job. You can select how
often the product performs a nozzle check in the
Setup
menu.
• Manually run a nozzle check from the product control panel, as described here.
1.
Load roll paper and select the matching paper type on the product control panel.
2.
Press the
maintenance button.
You see the
Maintenance
menu on the product control panel screen.
3.
Select
Nozzle Check
and press the
OK
button.
You see a confirmation message.
4.
Press the
OK
button.
The product prints a nozzle check pattern.
5.
Check the printed pattern to see if there are gaps in the lines.
Nozzles are clean
Summary of Contents for SureColor F6370
