Epson StylusRIP Professional (Stylus Photo 2200, Service Manual, Page: 201 / 258

EPSON Stylus PHOTO 2100/2200 Revision A
ADJUSTMENT Adjustments 201
5.2.4.1 PG Adjustment Method
1. When replacing the Printhead, make sure that there is no Shipping Liquid sticking
on the Head surface, and then install the Head on the Carriage unit.
2. Remove the Printer mechanism together with the Board unit from the Lower
housing, and place it on a level base.
3. Loosen the screws of the Adjust parallel bushes and Sub adjust parallel bushes.
4. Place the Release lever in the envelope mark position to increase the PG.
5. Press the jig setting position movement button in the servicing adjustment
program.
Figure 5-10. Adjustment Program
6. Screw the left and right PG gauge lead wires or arms to the Gauges, and matching
the Adjustment gauges to their respective edges, set them in the specified positions
(left end/right end of the rib on the Paper guide). At this time, make sure that the
Adjustment gauges are installed securely and evenly.
Figure 5-11. Adjustment Gauge Setting Positions
7. Press the right main shaft adjustment position movement button in the adjustment
program to move the Carriage to the PG main shaft right adjustment position.
C H E C K
P O I N T
When removing/reinstalling the Printhead, completely wipe the
drops of ink off the metal frame section on the Head nozzle
surface with the ASP cleaner blade, which was kept clean, or a
clean, soft cloth (cloth that will not fluff), and then install the
Printhead to the Carriage unit.
C A U T I O N
If the drops of ink and Shipping Liquid have stuck to the Head
nozzle surface or Nozzle plate metal frame, fully be careful since
the PG cannot be adjusted accurately due to continuity that occurs
before contact of the Nozzle plate metal frame and gauge
adjustment portions.
C H E C K
P O I N T
„
Before starting PG adjustment, load all Ink cartridges into the
CR unit. If the Ink cartridges have not been loaded, the CR
weight will be instable and the PG may not be adjusted properly.
„
After removing the Printer mechanism, place a rag or ASP
waste ink pad under the Waste ink tube to prevent the desk from
being contaminated.
„
Put the Printer mechanism on the flat stable work table. If you
adjust the PG on the unstable table that the suface is not flat, the
PG adjustment is affected by the table condition and the PG can
not be adjusted correctly even if the adjustment lever over the
adjusment range. So, after put the Printer mechanism on the
table, check that the printer dose not move rumbly by shaking
the mechanism on the table.
Setting positions
Gauge adjustment plates