Start Here
2
Lower the output tray, then open the extension.
3
Flip the feeder guard forward.
4
Squeeze the edge guide and slide it to the left.
5
Load paper against the right edge guide and behind the
tab, with the printable side face up.
4 x 6
(10 x 15 cm)
Letter or A4
Read these instructions before using your printer.
1
Unpack
Power cord
USB Cable
Caution:
Do not open the ink cartridge package until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all protective materials.
2
Turn on
1
Connect the power cable.
Caution:
Do not connect to your computer yet.
2
Press the
power button.
3
Install ink cartridges
Caution:
Keep ink cartridges out of the reach of children and do not drink
the ink.
Note:
The ink cartridges that come with your printer have a lower yield
due to the ink system charging process. This process is carried out the
first time you turn on your printer and guarantees better performance.
Don’t load paper before installing the ink cartridges.
1
Open the document cover, then open the ink cover.
Caution:
Don’t try to remove the ink cartridge guard or you may
damage the printer.
2
Shake the ink cartridges, then unpack them.
3
Remove only the yellow tape from each cartridge.
Caution:
Don’t remove any other seals from the cartridges.
4
Insert the cyan ink cartridge, and press it down until it clicks.
5
Press the
stop button. The cartridge holder moves.
6
Repeat steps 4 and 5 for other cartridges.
7
Close the ink cover, then close the document cover and
press the
stop button again.
8
Ink priming takes about 2 minutes. When the green power
light stops blinking, priming is complete.
Caution:
Don’t turn off the printer while it is priming or you’ll
waste ink.
4
Load paper
1
Open the paper support, then pull up the extension and tilt
it back slightly.
Epson Stylus
®
TX120
*411907900*
*411907900*
