Epson Stylus Pro 7400, Service Manual

Page: 318 / 428

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Adjustment Basic Adjustment 318
5.3.5 T&B&S + 980mm Band Feed
Paper feeding amount and the left, right, top and bottom margins can be adjusted using
this menu.
†
Paper Used
„
Size: 24” (Stylus Pro 7400/7800)
44” (Stylus Pro 9400/9800)
„
Type: Doubleweight Matte Paper
†
Specifications
„
Top margin: 10 ± 5 mm
„
Bottom margin: 14 ± 5 mm
„
Side margin: 10 ± 5 mm
„
980mm feed: 980mm ± 10 mm
†
Procedure
1. Start up the Adjustment Program and select [T&B&S + 980mm Band Feed].
2. Click the [Print] button to print the adjustment pattern.
3. Referring to
Figure 5-29 , measure the distance of the following four points.
†
Top margin
†
Bottom margin
†
Side margin
†
Band-feed amount
4. Enter the values measured in Step 3 into the corresponding edit boxes. (The
words inside the parentheses indicate the names displayed on the screen.)
†
Top margin (Top Margin)
†
Bottom margin (Bottom Margin)
†
Side margin (Side Margin Adjust)
†
Band-feed amount (980mm Feed)
5. Click the [Write] button and then click the [Print] button to print the
adjustment pattern again.
6. Perform Step 3 and Step 4 and click the [Write] button.
7. After confirming that the all values are within the specified range, click the
[Finish] button.
If they are not, perform
Step 3 to Step 5 again.
Figure 5-28. T&B&S (Roll Paper) + 980mm Band Feed Screen
C A U T I O N
Be sure to place the adjustment pattern print on a flat surface when
performing the measurement.