Epson Stylus Photo R290, Service Manual, Page: 77 / 125

EPSON Stylus Photo R280/R285/R290 Revision B
Chapter 4 Disassembly/Assembly 4.4.5 Waste Ink Tray (Disassembling the Printer Mechanism) 77
4.4.5 Waste Ink Tray
† Parts/Components need to be removed in advance
Printer Cover / Paper Support Assy / Upper Housing / Main Board Unit / Panel Assy /
Cover Open Sensor / Printer Mechanism
† Removal procedure
1. Remove the two screws, disengage the hook, and remove the Waste Ink Tray.
•
Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm) (No.4)
Figure 4-61. Removing the Waste Ink Tray
4.4.6 Waste Ink Pad
†
Parts/Components need to be removed in advance
Printer Cover / Paper Support Assy / Upper Housing / Main Board Unit / Panel Assy /
Cover Open Sensor / Printer Mechanism
† Removal procedure
1. Remove the three Waste Ink Pads from the trays.
Figure 4-62. Removing the Waste Ink Pad
C A U T I O N
When removing the Waste Ink Tray, take extra care not to spill
ink and contaminate the printer and surroundings.
A D J U S T M E N T
R E Q U I R E D
Whenever the Waste Ink Tray is replaced, the required
adjustments must be carried out.
•
Refer to "5.1.2 Required Adjustments" (p.99)
Waste Ink Tray
Hook
C A U T I O N
„
When removing the Waste Ink Pad, take extra care not to
contaminate the printer and surroundings with ink.
„ Be careful of the seven sharp edges shown in Fig.4-62 when
disassembling or reassembling.
Insert the Waste Ink Pads into the trays inserting the slits of the
pads over the tabs
on the trays. Make sure to push the pads as
far as they will go (until their top surface locate lower than the top
surface of the tray edges).
Figure 4-63. Installing the Waste Ink Pad
A D J U S T M E N T
R E Q U I R E D
Whenever the Waste Ink Pad is replaced, the required
adjustments must be carried out.
•
Refer to "5.1.2 Required Adjustments" (p.99)
Waste Ink Pad
Sharp edge
Slit
Tab