LCD Screen Messages
47
The index sheet is
marked incorrectly.
Remove the index sheet, mark it
correctly, and try again; see page 22.
The index sheet does
not match the photos on
the memory card.
Remove the memory card and insert the
card used to print the index sheet—or
place the correct index sheet on the
document table. Then press
x
Start
to
continue or
y
Stop/Clear Settings
to
cancel.
An error occurred during
photo pre-scanning.
Check that the photo is placed correctly
on the document table and try again; see
page 8.
An error occurred during
film pre-scanning.
Check that the film is placed correctly in
the film holder and on the document
table, and try again; see page 12.
Not enough ink to
perform head cleaning.
Install new ink cartridges; see page 41.
There is a problem with
the Epson Stylus
CX7700.
Turn the Epson Stylus CX7700 off and
then back on. If the error does not clear,
contact Epson; see page 50.
A part on the Epson
Stylus CX7700 needs to
be replaced.
Contact Epson; see page 50.
The waste ink pad is
nearly full.
Contact Epson; see page 50.
The memory card does
not contain any valid
photos.
Remove the memory card and check the
compatibility requirements on page 19.
Memory card error.
Remove the memory card and check the
compatibility requirements on page 19.
The connected camera
is not recognized.
Check the connection and try again; see
page 26.
The paper thickness
lever is set to the wrong
position.
Set the paper thickness lever to the
correct position and try again; see
page 7.
No memory card is
inserted.
Insert a valid memory card and try again;
see page 19.
Message
Cause
Solution
CX7700.book Page 47 Wednesday, July 27, 2005 5:57 PM
