Epson Stylus C82WN, Setup And Installation Manual

Page: 37 / 72

Configuring Wireless Printing for Macintosh
33
■ If you’re using a non-AirPort wireless adapter, make sure your Macintosh
computer’s wireless mode is set correctly. Set it to
Infrastructure
if you are
connecting through an access point, or
802.11b Ad Hoc
if you are connecting
without an access point.
If your adapter does not include an
802.11b Ad Hoc
option, set the wireless
mode to
Ad Hoc
,
Computer-to-Computer
, or whatever mode your adapter uses
to communicate without an access point. Do not select a pseudo ad hoc or
proprietary ad hoc mode. See the documentation for your wireless adapter for
details.
If you’re using infrastructure mode, make sure there is a link with good signal
strength (greater than 50 percent) between the Macintosh and base station or
access point. See your wireless adapter’s documentation for details.
If you’re configuring the print server from a Macintosh with a non-AirPort
wireless adapter, make sure WEP (Wired Equivalent Privacy) is disabled before
you begin. See the documentation for your wireless adapter for instructions.
Installing the C82WN Software
Your printer CD-ROM includes the following software:
■ EPSON Stylus C82WN printer driver
You must install the printer driver on every Macintosh that uses the EPSON
Stylus C82WN printer. This software controls print settings, monitors printer
status, and provides several utilities for printer maintenance. For instructions on
using your printer driver, see the
Printer Basics book.
■
WP-Admin
This utility lets you configure the print server for your network. You only need to
install it on one Macintosh, and in most cases it is the only configuration utility
you need to install.
■ EPSON Software Film Factory
This photo management program lets you organize, beautify, and print your
photos in a flash.
c82WN.book Page 33 Thursday, January 16, 2003 2:47 PM