Pins 7-8 on jumper J6 control odd
parity
checking by the drive as
shown in the
table below.
Pins 7-8
X = Jumper installed
0 = No jumper
= Factory setting
Set J6 to enabled if the devices connected to the
SCSI
adapter card
support parity checking. If one or more devices connected to the SCSI
adapter card do not support parity checking, set the jumper to disabled.
Drive power-up
Pins
9-10
on jumper J6 control when the hard disk drive receives power
as shown in the table below.
I
Drive receives power
I
Pins 9-10
When computer is
on*
I
X
I
At first START
r
command from
initiator
0
X = Jumper installed
0 = No jumper
= Factory setting
Do not change the factory setting of this jumper.
6
Installing the Drive
Summary of Contents for SCSI Hard Disk Drive
Page 5: ...E ...
