S5U1C88816P MANUAL
EPSON
1
(PERIPHERAL CIRCUIT BOARD FOR S1C88816/8F360)
1 INTRODUCTION
1 INTRODUCTION
1.1 S5U1C88816P Outline
The S5U1C88816P board provides the peripheral
circuits other than the core CPU, for the S1C88816/
8F360. Consequently, you should install it into the
ICE and use it as the emulator for the S1C88816/
8F360 models.
The S5U1C88816P is equipped with LEDs and
terminals for monitoring the internal operating
conditions, I/O connection connectors for the
target system and other appropriate devices.
1.2 S5U1C88816P Components
When unpacking the S5U1C88816P, check that the
following goods are present:
(1) S5U1C88816P board ....................................... 1
(2)
I/O connection cable (80-pin/40-pin flat type
×
2) ..
2 sets
(60-pin/30-pin flat type
×
2) ..
1 set
(3) I/O connector for target system (40-pin) ......... 4
(30-pin) ......... 2
(4) Cable for monitor terminal (10-pin) ................ 1
(5) S5U1C88816P Manual (Peripheral Circuit
Board for S1C88816/8F360) (this manual) ..... 1
(6) Warranty .......................................................... 1
(7) Warranty registration card ............................... 1
(8) Report on the factory test ................................. 1
(9) Note for using .................................................. 1
1.3 S5U1C88816P External Diagram
Fig. 1.3.1 S5U1C88816P external drawing
Note: Keep the JP switch on the S5U1C88816P
board as it was set prior to factory shipment.
In no case should you remove it or change
it.
I/O #
2
I/O #
1
I/O #
3
MON
ITOR
VSV
D
LCDC
SVDO
N
OSCC
VDC1
RES
ET
LCD4
.5V
LCD5
.5V
EXLC
D
HVLD
MOD
E
VDC2
VDC0
EPSON
E0C
8881
6/F3
60 P
eriph
eral c
ircuit b
oard
PRC88816
Mother board J2 connector
Mother board J1 connector
RESET switch
LED
VSVD volume
Monitor connector for LED
I/O#2 connector
I/O#3 connector
I/O#1 connector
Monitor pins
GND
OSC1CR
VR3 (OSC3CR ADJ)
VR2 (OSC1CR ADJ)
OSC3CR
∗
The name 'PRC88816' on the
development tool is the old
name of the product.