CHAPTER 2: SETTING UP THE S5U1C88000P
S5U1C88000P MANUAL
EPSON
3
(S1C88 FAMILY PERIPHERAL CIRCUIT BOARD)
2.2 Downloading Circuit Data
This board (S5U1C88000P) comes with the FPGA that contains factory inspection data, therefore the
circuit data for the model to be used should be downloaded. The following explains the downloading
procedure.
1) Set the switch "SW1"
*
1
on this board to the "3" position.
2) Install this board to the ICE (S5U1C88000H5) as shown in Section 2.1.
3) Connect the ICE to the host PC. Then turn the host PC and ICE on.
4) Invoke the debugger included in the ICE or assembler package. For how to use the ICE and debugger,
refer to the manuals supplied with the ICE and assembler package.
5) Download the circuit data file (.mot) corresponding to the model by entering the following commands
in the command window.
>XFER
(erase all)
>XFWR
<file name>
(download the specified file)
*
2
>XFCP
<file name>
(compare the specified file and downloaded data)
6) Terminate the debugger and then turn the ICE off.
7) Remove this board from the ICE and set the switch "SW1" on the board to the "1" position.
8) Install this board to the ICE again.
9) Turn the ICE on and invoke the debugger again. Debugging can be started here.
∗
1 See Figure 1.3.1, "External view of S5U1C88000P", for the location of SW1.
∗
2 The downloading takes about 5 minutes.
